“UbuntuHelp:BinaryDriverHowto/KeyspanDriver”的版本间的差异
来自Ubuntu中文
小 |
小 |
||
| 第10行： | 第10行： | ||
This is a very rushed stab at an explanation, mainly so I can get the page out there, and tidy it up later. Sorry for the mess. :( | This is a very rushed stab at an explanation, mainly so I can get the page out there, and tidy it up later. Sorry for the mess. :( | ||
---- | ---- | ||
| − | [[category:CategoryDocumentation]] [[category:CategoryCleanup]] | + | [[/PageDiscussion|Discuss this page.]] |
| + | Categories: [[category:CategoryDocumentation]] [[category:CategoryCleanup]] | ||
[[category:UbuntuHelp]] | [[category:UbuntuHelp]] | ||
2008年10月19日 (日) 04:23的版本
 |
点击翻译: |
English |
请不要直接编辑翻译本页，本页将定期与来源同步。 |
How to install the non-free firmware for Keyspan USB <-> serial converters
KeyspanDriverHowto:: This Howto documents how to get a Keyspan USB-to-serial converter working with Ubuntu. Most of these devices require firmware to be downloaded to the device each time you connect it to your USB bus. The problem is that this firmware is distributed with a license too restrictive to allow Ubuntu to redistribute it.
Use a kernel.org kernel
Compile your own kernel from kernel.org source. See the KernelCompileHowto for more information on how to do this.
Patch the ubuntu kernel
This is a bit sneakier. For now, I will say that you need to download the kernel.org kernel, and copy keyspan* from drivers/usb/serial to drivers/usb/serial in the unpacked ubuntu kernel tree. Also, copy the relevant bits from Kconfig in the upstream drivers/usb/serial directory into Kconfig in the same directory under the Unbutu source tree. Then compile it, using the KernelCompileHowto as a guide. This is a very rushed stab at an explanation, mainly so I can get the page out there, and tidy it up later. Sorry for the mess. :(
Discuss this page. Categories:
